Influence of the rate of directional crystallization and silicon content on the structure and strength of the Al-Si-Cu alloy
Nikanorov S.P.1, Osipov V. N.1, Timashov R. B.1, Chikiryaka A. V.1
1Ioffe Institute, St. Petersburg, Russia
Email: s.nikanorov@mail.ioffe.ru, osvn@mail.ioffe.ru, timashov@inbox.ru, chikiryaka@mail.ru

PDF
The structure and strength of AlxSi-2wt.%Cu (x = 15, 17 and 20 wt.%) alloys obtained by directional solidification at a rate of 0.1 and 0.8 mm/s are investigated. It is shown that the tensile strength increases with an increase in the rate of solidification due to a decrease in the size of eutectic silicon and the transformation of its crystal flake into a fine-fiber one. In addition, there was an increase in tensile strength due to an increase of the share of the intermetallic phase, exceeding the reduced tensile strength due to an increase in the amount of the α-Al phase. An increase in the silicon content in the samples during solidification at a rate of 0.1 mm/s does not lead to a change in structure and strength. At a higher rate of solidification, there is a reduction of the share of eutectic and a decrease in strength. Keywords: aluminum alloys, eutectic, structure, tensile strength.
  1. G.B. Stroganov, V.A. Rotenberg, G.B. Gershman. Splavy alyuminiya s kremniyem (Metallurgiya, M., 1977) (in Russian)
  2. M.V. Popova, V.V. Ushakova, Z.A. Luzyanina. Izv. vuzov. Chernaya metallurgiya, 8, 55 (1995). (in Russian)
  3. M.V. Popova, V.V. Ushakova, Z.A. Luzyanina. Izv. vuzov. Chernaya metallurgiya, 6, 81 (1994) (in Russian)
  4. V. Vijeesh, K. Narayan Prabhu. Trans. Indian Inst. Met., 67 (1), 1 (2014). DOI: 10.1007/s12666-013-0327-x
  5. V.N. Osipov. ZhTF, 92 (9), 1365 (2022) (in Russian). DOI: 10.21883/JTF.2022.09.52928.42-22
  6. Yu.Ya. Zilberg, N.M. Khrushcheva, G.B. Gershman. Alyuminiyevyye splavy v traktorostroyenii (Mashinostroyeniye, M., 1971) (In Russian)
  7. T.N. Smirnova. Modifitsirovaniye zaevtekticheskikh siluminov. V sb.: Modifitsirovaniye siluminov. Pod red G.V. Samsonova. Nauk. dumka, Kiev (1970), p. 25. (in Russian)
  8. A.P. Gudchenko, I.M. Zalivanova. Liteynoye proizvodstvo, 12, 30 (1972) (in Russian)
  9. L.P. Seleznev, T.P. Borovitskaya, E.V. Kuznetsova. Nauchnyye trudy Instituta Giprotsvetmetobrabotka, 58, 63 (1978) (in Russian)
  10. Y.C. Lin, Shun-Cun Luo, Jian Huang, Liang-Xing Yin, Xing-You Jiang. Mat. Sci. Eng. A 725, 530 (2018). DOI: 10.1016/j.msea.2018.04.049
  11. S. Hegde, K.N. Prabhu. J. Mater.Sci., 43 (9), 3009 (2008). DOI: 10.1007/s10853-008-2505-5
  12. K.V. Nikitin. Modifitsirovaniye i kompleksnaya obrabotka siluminov (Samarskiy gosudarstvennyy tekhnicheskiy universitet, Samara, 2016) (in Russian)
  13. G.K. Sigworth. Int. J. Metalcast., 2 (2), 19 (2008). DOI: 10.1007/BF03355425
  14. L.F. Mondolfo. Aluminum Alloys: Structure and Properties (London, Butterworth Ltd., 1976)
  15. A.I. Averkin, B.N. Korchunov, S.P. Nikanorov, V.N. Osipov. Tech. Phys. Lett., 42 (2), 201 (2016). DOI: 10.1134/S106378501602019X
  16. S.P. Nikanorov, L.I. Derkachenko, B.K. Kardashev, B.N. Korchunov, V.N. Osipov, V.V. Shpeizman. Phys. Solid State, 55 (6), 1207 (2013). DOI: 10.1134/S1063783413060255
  17. C.G. Shivarprasad, S. Narendranath, Vijay Desai, Sujeeth Swami, M.S. Ganesha Prasad. Proc. Mat. Sci., 5, 1368 (2014). DOI: 10.1016/j.mspro.2014.07.454
  18. L. Aguilera Luna, H. Mancha Molinar, M.J. Castro Roman, J.C. Escobedo Bocardo, M. Herrera Trejo. Mater. Sci. Eng. A, 561, 1 (2013). DOI: 10.1016/j.msea.2012.10.064
  19. H. Borkar, S. Seifeddine, A.E.W. Jarfors. Sol. St. Fen., 287, 18 (2019). DOI: 10.4028/www.scientific.net/SSP.287
  20. M. Okayasu, Y. Ohkura, S. Takeuchi, H. Ohfuji, T. Shiraishi. Mat. Sci. Eng. A, 543, 185 (2012). DOI: 10.1016/j.msea.2012.02.073
  21. M. Okayasu, S. Takeuchi, T. Ochi. Int. J. Cast Metal. Res., 30 (4), 217 (2017). DOI: 10.1080/13640461.2017.1286556
  22. T. Hosch, L.G. England, R.E. Napolitano. J. Mater. Sci., 44 (18), 4892 (2009). DOI: 10.1007/s10853-009-3747-6
  23. L. Tian, Y. Guo, J. Li, F. Xia, M. Liang, Y. Bai. Materials, 11 (7), 1230 (2018). DOI: 10.3390/ma11071230
  24. O.A. Atasoy, F. Yilmaz, R. Elliott. J. Cryst. Growth, 66 (1), 137 (1984). DOI: 10.1016/0022-0248(84)90084-8
  25. R. Wang, W. Lu. Int. J. Mater. Sci. Appl., 5 (6), 277 (2016). DOI: 10.11648/j.ijmsa.20160506.17
  26. M.B. Djurdjevic. Vojnotechni\^cki Glasnik/Military Technical Courier, 60 (1), 152 (2012). DOI: 10.5937/VojnotehnickiGlasnik
  27. D.C. Jenkinson, L.M. Hogan. J. Cryst. Growth, 28 (2), 171 (1975). DOI: 10.1016/0022-0248(75)90233-X
  28. S.P. Nikanorov, V.N. Osipov, L.I. Regel. J. Mater. Eng. Perform., 28, 7302 (2019). DOI: 10.1007/s11665-019-04414-3
  29. V. Vijeesh, M. Ravi, K. Narayan Prabhu. Mater. Perform. Character., 2 (1), 296 (2013). DOI: 10.1520/MPC20120007

Подсчитывается количество просмотров абстрактов ("html" на диаграммах) и полных версий статей ("pdf"). Просмотры с одинаковых IP-адресов засчитываются, если происходят с интервалом не менее 2-х часов.

Дата начала обработки статистических данных - 27 января 2016 г.

Publisher:

Ioffe Institute

Institute Officers:

Director: Sergei V. Ivanov

Contact us:

26 Polytekhnicheskaya, Saint Petersburg 194021, Russian Federation
Fax: +7 (812) 297 1017
Phone: +7 (812) 297 2245
E-mail: post@mail.ioffe.ru